Table of Contents
Advertisement
Arriva condensate drain kit connection
The condensate drain kit is provided with the ASPKIT03. It is used in vertical flue installations for
draining condensate back into the heater.
Condensate
drain hose
Condensate
tube
At least 10mm
penetration of
barb is required
Rubber drain
outlet
Condensate
hose
Before connecting the condensate drain hose to the condensate trap ensure that there are no
kinks in the condensate drain hose. Also ensure the path of the condensate drain hose is kept
away from hot surfaces. Failure to install the condensate kit correctly may cause damage to the
heater and flue system.
1. Insert the barbed end of the condensate tube into the condensate drain hose. Ensure that the
barb penetrates the hose by at least 10 mm.
2. Locate the condensate tube insertion point, which is a rubber grommet found at the rear of the
heater, to the right of the combustion air hose connection.
3. Uncoil the condensate drain hose and secure it to the rear of the heater using the upper screw
of the combustion fan cover and the wire tie provided.
4. Connect the free end of the condensate drain hose to the rubber drain outlet of the condensate
trap by pushing the hose inside the rubber connection to a minimum of 20 mm, but not greater
than 30 mm (this can cause a blockage).
5. Place the condensate tray into the heater (short end first) making sure that the tray is centered
under the end of the condensate tube.
24 | Arriva/Evolve flue installation guide: 10726-I 09-21
Combustion air hose connection
Rubber grommet
insertion point for
condensate tube
REAR
2
FRONT
Condensate tube inserted
up to the 90° bend
Secure
Rubber grommet
for condensate tube
Condensate tray
Short end towards rear of heater and long end towards front of heater
Wire tie
Condensate tube
Advertisement
Table of Contents
