Table of Contents
Advertisement
Parts list
The following parts are provided with the Universal Two-Post Rack Kit (XBR-R000294).
FIGURE 7
Rack kit parts
1
Front brackets (2)
2
Rear brackets, 5-6 inch post (2)
3
Rear brackets, 3-5 inch post (2)
4
Screw, 8-32 x 5/16-in., panhead Phillips (8)
Ensure that the items listed and illustrated in
depending on the device type.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the device.
Flush-front mounting
CAUTION
The device must be turned off and disconnected from the fabric during this procedure.
Complete the following tasks to install the device in a two-post rack.
1.
"Attaching the front brackets"
2.
"Attaching the front brackets to the rack posts"
3.
"Attaching the rear brackets to the rack posts"
ExtremeSwitching SLX 9140 Hardware Installation Guide
9036857-00 Rev AA
5
Screw, 8-32 x 5/16-in., flathead Phillips (16)
6
Screw, 6-32 x 1/4-in., panhead Phillips (8)
7
Screw, 10-32 x 5/8-in., panhead Phillips (8)
8
Retainer nut, 10-32 (8)
Figure 7
are included in the kit. Note that not all parts may be used with certain installations
on page 18
on page 18
on page 19
Installing the Universal Two-Post Rack Kit (XBR-R000294)
17
Advertisement
Table of Contents
