Extreme Networks ExtremeSwitching SLX 9140 Hardware Installation Manual page 25

FIGURE 5 Positioning the device in the rack
1 Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1. Slide the right rear bracket into the right front bracket and the left rear bracket into the left front bracket.
2. Adjust the rear brackets to the rack depth.
3. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts, as
shown in Figure 6. Use the upper and lower holes in the bracket.
4. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
5. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
ExtremeSwitching SLX 9140 Hardware Installation Guide
9036857-00 Rev AA
2 Retainer nuts, 10-32
Four-post rack mount installation (XBR-R000297)
15