Management Port Leds - Extreme Networks 8520 Series Hardware Installation Manual

RJ-45 Management Port LEDs
Table 9: System Status LEDs (continued)
LED
PSU Status
Secure
RJ-45 Management Port LEDs
The 10/100/1000Base-T RJ-45 Management port includes two LEDs that are both amber and green.
The LEDs are located on each side of the RJ-45 port. The LED on the right side is labeled Speed and the
LED on the left side is labeled Link/Activity. The following table describes the meaning of the colors and
states for the LEDs.
Table 10: 10/100/1000Base-T RJ-45 Management Port LEDs
LED
Speed
Link/Activity
56 Extreme 8520 Series Hardware Installation Guide
Color/State
Off
Green
Blinking amber
Amber
Off
Blinking blue slowly (1 Hz)
Blinking blue fast (4 Hz)
Blinking blue very slowly
(0.25 Hz)
Blue
Color/State
Off
Green
Amber
Green
Blinking green
Blinking slowly green
Amber
Description
No power.
Power on. Main and Standby output enabled
with no PSU warning or fault detected.
Warning. Power supply warning detected.
Fault. Power supply fault.
CeC1712 is booting up or fault. CeC1712 is
performing the initial load (decrypt, validate,
load) of its own code, prior to authenticating
images. Or the CeC1712 was unable to
decrypt, validate and load its own image.
CeC1712 is authenticating or updating images.
CeC1712 is currently authenticating or
copying golden image to primary.
CeC1712 authentication failed. Neither
primary nor golden image successfully
validated.
Bypass authentication. Bypassing
authentication for test or development only.
CeC1712 authentication complete. CeC1712
successfully authenticated the BIOS Flash-0
and BMC Flash-0 images.
Description
The port is operating at 10 Mbps.
The port is operating at 1 Gbps.
The port is operating at 100
Mbps.
The port has link established.
There is no data activity.
The port has link established and
there is data activity.
The port is disabled by the
admin.
Fault.
Monitor the Switch