Installing A Replacement Bail On An Older Optiview Analyzer - Fluke OptiView Getting Started Manual

Installing a Replacement Bail on an Older OptiView
Analyzer
With the bail nearly closed on the analyzer, grip one side of the bail by where it
pivots on the analyzer and gently pull. It should pop out with little effort. Do the
same for the opposite side. See figure 10 below.
The bail must be nearly shut before removing or installing,
or damage may occur to the analyzer case.
With the new analyzer bail placed in the nearly shut position, install it one side at a
time by placing the pivot arm in the pivot hole on the analyzer and gently pushing
until it pops into the hole and pivots freely. Do the same for the other side.
Figure 12. OptiView Wireless Network Analyzer Bail Removal

Installing a Replacement Bail on an Older OptiView Analyzer

Caution
Wireless Network Analyzer
Stylus
apo04f.eps
21