Installing The Software On The Analyzer - Fluke OptiView Getting Started Manual

Installing the Software on the Analyzer

After the file OPVWNA-V2.EXE has been copied to the Analyzer (preferably to the
D: drive), perform the following steps to complete the installation:
The Wireless Network Analyzer PCMCIA Card must NOT be
installed in the analyzer during the software installation. After the
software installation, the card can be inserted into the PCMCIA slot.
Windows will then detect the card and add it as new hardware using
the correct driver.
1. Run OPVWNA-V2.EXE file.
2. Follow the InstallShield Wizard instructions to install the software.
Reboot the Analyzer as indicated in the InstallShield Wizard.
3. Once the Analyzer reboots, stop the OptiView application if it is running.
Running both the OptiView application and the OptiView Wireless
Network Analyzer at the same time is NOT recommended.
4. Install the 802.11a/b/g wireless LAN card in the PCMCIA slot on the side
of the OptiView Integrated Network Analyzer. The New Hardware
Wizard will detect the card and properly configure the Analyzer.
5. Click on the OptiView Wireless Network Analyzer icon
software.
Installing the OptiView Wireless Network Analyzer Software
Note
Note
Wireless Network Analyzer
to start the
9