Avaya 6424D+M User Manual page 41

Speed
Option Values: 1200, 2400, 4800, 9600, 19.2, 38.4, 57.6 Kbps
Applicable Data Protocols: All
Use this option to change the speed at which data communications take place. To set this option
from an asynchronous attached terminal, do the following:
1 Type set speed value (for example, set speed 9600) to tell the ADM the speed at which
you want to communicate.
2 Change your data terminal speed. (See your terminal's operating manual for instructions.)
3 Press .
RETURN
You can also change the speed from your asynchronous data terminal (when the Autoadjust
option is "on") by pressing the
Note:
Using autoadjust only temporarily activates the current speed and parity. You can store
speed and parity by setting the options through the voice terminal keypad or by copying
data option profile pA to p1 (see "Data Option Profiles", later in this chapter).
Short, high quality cables are strongly recommended for use with high speeds: 38.4 and 57.6
Kbps.
Text
Option Values: verbal, diagnostic, off, q2_verbal, q2_diagnostic
Applicable Data Protocols: All
This option determines whether the ADM provides call progress and error messages to your
attached terminal during call setup and disconnection.
Call progress and error messages describe the status of your call. Select verbal if you want
verbal messages to appear on your attached terminal during call progress. Select diagnostic if
you want only a numeric diagnostic code to appear in addition to the progress message. Select
off if you do not want to see these messages.
Q2_verbal and q2_diagnostic are similar to verbal and diagnostic, except that in AT Local Mode,
the Q register is set to value 2.
See Appendix A: Cause Code Tables for a listing of the error messages.
Trans.flow (Transmit Flow Control)
Option Values: xon/xoff, eia, off
Applicable Data Protocols: X.25, Mode 3, all V.120 modes, and Mode 2*
key, typing AT and then pressing
BREAK
.
RETURN
Data Options and Profiles 4-13