Operation; Radio Mode; Alarm Mode - Grundig Sonoclock 790 DCF Manual

OPERATION

Switching on and off
1 Press » « to switch on the device
from standby mode.
2 Press » « to switch the device to
standby mode.

Radio mode

For the best possible FM (VHF) re-
ception, it is sufficient to align the
wire antenna accordingly.
Tuning to radio stations
1
Select the radio station using the
»-TUNING+« dial.
Adjusting the volume
1
Adjust the volume by pressing
»HOUR/VOL+« or »MIN/VOL-«.

Alarm mode

The device has a dynamic alarm tone
that starts at a low volume and reach-
es its maximum volume within 30 to
45 seconds.
Viewing the alarm time
1
Press »SET« twice (for alarm time
1) or three times (for alarm time 2).
– Display: the last set alarm time
1 or 2, the LED
»AL 2
_____________________________________
»AL 1
« flashes.
Note:
If no other button is pressed, the
7
device switches back automati-
cally to the current time after
10 seconds.
Alarm with radio station
1
Press » « to switch on the device.
2 Select the radio station using the
»-TUNING+« dial.
3
Adjust the alarm volume by pressing
»HOUR/VOL+« or »MIN/VOL-«.
4
Set the radio station you want as
an alarm signal (» «), and press
»AL1« or
– Display: the corresponding LED
»AL 1
lights up.
5
Press » « to switch off the device.
– The device wakes you up at the
set time with the radio station
(alarm duration is 59 minutes).
Alarm with signal tone
1
Press » « to switch off the device.
2
Set the signal tone alarm signal
(» «), and press
once.
« or
– The device wakes you up at
the set time with the signal tone
(alarm duration is 59 minutes).
2« twice.
»AL
»AL 2
« or
1« or
»AL
ENGLISH 23
«
2«
»AL