Power Supply; Mains Operation; Environmental Note - Grundig SCC 240 Manual

POWER­SUPPLY
Mains­operation
Check that the mains voltage on
the type plate (on the bottom of the
device) corresponds to your local
mains supply. If this is not the case,
contact your specialist dealer.
1
Plug the mains cable into the so-
cket (230V ~ , 50/60 Hz).
Caution:
The device is connected to the
7
mains with the power plug. To
fully disconnect the device from
the mains, pull out the plug.
The mains plug is used to dis-
7
connect the device. It shall
remain readily operable and
should not be obstructed during
intended use.
­ 8 ENGLISH
­ ________________________________
Inserting­the­back-up­
battery
During mains operation, the back-up
battery ensures that stored settings
are not lost in the case of a power
failure or when the device is briefly
disconnected from the mains.
1
Open the battery compartment lid
by pressing on the arrow and pus-
hing down the lid.
2
When inserting the battery
batteries, 2 x 1.5 V, LR3/ UM 4/
AAA), observe the polarity marked
on the base of the battery compart-
ment.
Note:
7
Environmental­note:
7
Remove the back-up battery
when it is flat or when you know
that the device will not be used
for a long period of time.
Batteries, including those which
do not contain heavy metal,
should not be disposed of
with household waste. Always
dispose of used batteries in
accordance with local environ-
mental regulations.
(micro