Table of Contents
Advertisement
Safety Instructions
1.4 Electrical Inspection
1.4.4
Safety Notes
!
DANGER
Danger during electrical inspection.
If you do not comply with the safety notes, this will result in death, severe injury, or considerable material
damage.
Comply with all given safety notes when carrying out the electrical inspection.
²
Note that hazardous voltages are present when you perform the electrical inspection.
²
During the electrical inspection, check that the device becomes ready for operation once it has been
²
connected to the power supply.
Performing the Electrical Inspection
1.4.5
Connect the power supply.
²
Activate the power supply.
²
The device must have the normal operating state (process mode) if the configuration, connection, and
²
transmission have been set up successfully. The device must communicate with the PC. If not, discon-
nect and check the installation of the device and the installation and configuration of the service program
PowerSys (refer to Chapter 4).
If a defect of the device is suspected, please contact the Customer Support prior to a return to manufac-
²
turer. If the suspect for a defect is confirmed by Customer Support, pack the device and return it to the
manufacturer, stating the defect. Use transport packaging that meets the requirements.
14
Smart Communications, PowerLink 100 and PowerLink 50, Product Information
E50405-U53-X-B3-7670, Edition 11.2014
Advertisement
Table of Contents
