Table of Contents
Advertisement
Service Program PowerSys
7.3 Installation of the Service Program PowerSys
7.3
Installation of the Service Program PowerSys
With the service program PowerSys versions P3.5.x and higher, multiple installation is possible. Older
versions can be removed.
You can uninstall older PowerSys versions via Start > Settings > Control Panel > Add or Remove Programs
by clicking Remove.
NOTE
i
i
Data files stored in older versions, for example, in C:\Program Files\PowerSys\P3.x.y\DeviceFiles are not
uninstalled and may be used again after reinstalling the older version.
The new service program PowerSys is delivered on a DVD. Run the setup.exe for the installation. The
program leads you through the installation.
[scpowrsy-300414-01.tif, 1, en_US]
Figure 7-1
NOTE
i
i
Regional and Language Options (settings) other than German or English (UK) can cause problems.
Siemens strongly recommends that you switch Windows to one of the mentioned settings (Start > Control
panel > Regional and Language Options). Reasons for the problems are the different formats for numbers,
date, and time.
With the installation setup of the PowerSys software a hardware driver for the SWT 3000 PU4 CP2102 USB
to UART Bridge Controller is pre-installed in a second step. The driver is required for the connection of the
service PC to the USB interface of the SWT 3000 on PU4 module.
The installation and activation of the driver is managed automatically by the Windows hardware installation
wizard for Plug-and-Play devices with first connection of the PC to the SWT 3000. The COM-port number is
assigned automatically to the next free serial port.
52
Splash Screen of the Installer for Installation of the Service Program PowerSys
Smart Communications, PowerLink 100 and PowerLink 50, Product Information
E50405-U53-X-B3-7670, Edition 11.2014
Advertisement
Table of Contents
