Audiovox VBP4000 Owner's Manual page 11

4. Installing the detached monitor onto the seat back in a
car (Refer to Figure 10)
1) Follow the installation instruction shown in Item 1, 2 or 3.
2) Detach the monitor from the main unit by depressing the but-
ton below the screen with one hand and remove the monitor with
the other hand. Take the pouch from the rear compartment of the
bag. Slide the monitor into the pouch, and make sure to feed the
bottom piece of the pouch into the long slot at the bottom of the
monitor and attach the Velcro strap to fasten the monitor in the
pouch. Then loop the strap of the pouch around the headrest
and pull the end of the strap while holding the buckle until the
pouch is tightly secured.
3) Insert one end of the DIN cable into the PORT on the right side
of the detached monitor, and the other end into either MONITOR
1 port or MONITOR 2 port on the left side of the main unit.
Figure 10
11