Parameters - Siemens SIMATIC ET 200SP Manual

Parameters/address space

5.2 Parameters

5.2 Parameters
Parameters of the AI 2xU/I 2-/4-wire HF
The following table lists the configurable parameters. The effective range of the configurable
parameters depends on the type of configuration. The following configurations are possible:
• Central operation with an ET 200SP CPU
• Distributed operation on PROFINET IO in an ET 200SP system
• Distributed operation on PROFIBUS DP in an ET 200SP system
When assigning parameters in the user program, use the WRREC instruction to transfer the
parameters to the module by means of data records; refer to the section Parameter
assignment and structure of parameter data record (Page 55).
The following parameter settings are possible:
Table 5- 2 Configurable parameters and their defaults (GSD file)
Parameter
Diagnostics
No supply voltage L+
Diagnostics:
Short-circuit to ground
Diagnostics:
Overflow
Diagnostics:
Underflow
Diagnostics:
Wire break
22
Range of values Default
Disable
• Disable
• Enable
Disable
• Disable
• Enable
Disable
• Disable
• Enable
Disable
• Disable
• Enable
Disable
• Disable
• Enable
Configuration Scope with configuration soft-
in RUN
PROFINET IO
Yes Channel
Yes Channel
Yes Channel
Yes Channel
Yes Channel
Analog input module AI 2xU/I 2-/4-wire HF (6ES7134-6HB00-0CA1)
Equipment Manual, 05/21, A5E51055079-AA
ware, e.g. STEP 7 (TIA Portal)
GSD file GSD file
PROFIBUS DP
Channel
Channel
Channel
Channel
Channel