Advertisement
1000 Series ATW-R10 Receiver or ATW-D12a VHF Antenna Distribution System Using the rack ears included
with this kit, assemble the antenna adapters as shown in Figure 3. For best reception, the antennas should be fully
extended and positioned in the shape of a "V" (45° from vertical).
Figure 3
6
3
1100 Series ATW-R11 or PRO-R2 Receiver Using the rack ears provided with the receiver, assemble the antenna
adapters as shown in Figure 4. For best reception, the antennas should be fully extended and positioned in the shape
of a "V" (45° from vertical).
1900 Series ATW-R19 Receiver, ATW-D70 and ATW-D90 UHF Antenna Distribution Systems Same as above
except use BNC adapter to attach cable to receiver antenna jack. Do not extend the antennas; use them fully collapsed.
Figure 4
Position
5
inside mounting
hole
After Installation
Make certain that the antenna cables' ring terminals are not in contact with any metal part of the equipment rack.
Always rotate the antennas in the clockwise direction when positioning. This will ensure that the antennas do not
become loose or intermittent.
Extensive information about using wireless systems and accessories is available on the Audio-Technica
Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224 330/686-2600
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England (0)113 277 1441
8
3
7
2
1
8
3
7
4
4
3
2
1
www.audio-technica.com
Web site at www.audio-technica.com
P50910-03-B/W ©1999 Audio-Technica U.S., Inc. Printed in U.S.A.
Advertisement
