Specifications; Optional System Accessories - Audio Technica ATW-201 Installation And Operation Manual

OVERALL SYSTEM
Operating Frequency
Frequency Stability
Modulation Mode
Maximum Deviation
Operating Range
Operating Temperature Range
Frequency Response
RECEIVER
Receiving System
Image Rejection
Signal-to-noise Ratio
Total Harmonic Distortion
Sensitivity
Audio Output
Output Connector
Power Supply
Dimensions
Net Weight
Accessories Included
WIRELESS ESSENTIALS ™ MICROPHONES AND CABLES
All Wireless Essentials accessories are terminated for use with ATW-T201
and other UniPak ™ transmitters.
AT829cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen. Provided with
ATW-201/L systems.
MT830cW Subminiature omnidirectional condenser lavalier
microphone. Includes clothing clip and windscreen.
MT830cW-TH "Theater" model, same as MT830cW except beige color
mic and cable for concealment.
AT831cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
AT851cW Surface-mount wide-range hemi-cardioid condenser
microphone.
AT857AMLcW 19" gooseneck cardioid microphone.
Mounts to 5 / "-27 thread. Includes windscreen.
8
AT889cW Headworn noise-canceling condenser microphone.
Includes windscreen and cable clip.
ATM35cW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
ATM73cW Headworn cardioid condenser microphone.
Includes windscreen.
ATM75cW Headworn cardioid condenser microphone.
Includes windscreen.
PRO 8HEcW Headworn hypercardioid dynamic microphone.
Includes windscreen and cable clip. Provided with
ATW-201/H systems.
PRO 35xcW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
VHF high band, 169 MHz to 172 MHz
±0.005%
FM
±15 kHz
200' minimum
40° F (4° C) to 110° F (43° C)
80 Hz to 13 kHz
Non-diversity, single-channel,
dual antenna system
50 dB minimum
80 dB at 10 kHz deviation (IEC-weighted),
maximum modulation 15 kHz
≤1% (10 kHz deviation at 1 kHz)
20 dBµV for 60 dB S/N (IEC-weighted)
350 mV (1 kHz modulation, 10 kHz
deviation, 100k ohm load)
1 / " TS ("mono") phone jack
4
120V AC 60 Hz, 6 VA; or 12V DC, 200 mA,
center positive, with external DC supply
8.27" (210.0 mm) W x 1.72" (43.5 mm) H
x 4.73" (120.0 mm) D
18.9 oz (536 grams); without AC adapter,
11.9 oz (336 grams)
AD1202A 120V docking AC adapter;
120V AC IEC cordset

Optional System Accessories

Specifications

†
UNIPAK ™ TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Input Connections
Battery
Current Consumption
Battery Life
Dimensions
Net Weight (without battery)
HANDHELD TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Microphone Element
Battery
Current Consumption
Battery Life
Dimensions
Net Weight (without battery)
Accessory Included
† In the interest of standards development, A.T.U.S. offers full details on its test methods to
other industry professionals on request.
AT-GCW Hi-Z instrument/guitar cable with
with ATW-201/G systems.
XLRW Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
OTHER ACCESSORIES
AT8114 Foam windscreen for handheld transmitter.
AT8141 Water-resistant pouch for UniPak transmitter.
AT8390 Shielded audio cable with
Available in a variety of lengths.
(Also available with one straight and one 90° phone plug
as the AT8316.)
AT8456a Stand clamp for handheld transmitter,
ATW-VP10 Vinyl pouch with belt clip to hold UniPak transmitter.
10 mW High position, 2 mW Low position,
typical
Under federal regulations
≥90 dB, A-weighted
High impedance, low impedance, bias
9V (NEDA type 1604) alkaline,
not included
30 mA typical
Approximately 15 hours in High position
Approximately 20 hours in Low position
2.56" (65.0 mm) W x 4.33" (110.0 mm) H
x 1.00" (25.4 mm) D
2.8 oz (78 grams)
10 mW High position, 2 mW Low position,
typical
Under federal regulations
≥90 dB, A-weighted
Dynamic unidirectional
9V (NEDA type 1604) alkaline,
not included
30 mA typical
Approximately 15 hours in High position
Approximately 20 hours in Low position
9.50" (241.3 mm) long, 2.10" (53.3 mm)
diameter
12.7 oz (360 grams)
AT8456a stand clamp
/ " phone plug. Provided
1
4
1 / " to 1 / " phone plugs.
4 4
5 / "-27 threads.
8
7