Audio Technica ATW-251 Installation And Operation Manual
200 series professional vhf wireless systems unipak system guitar system headworn microphone system lavalier microphone system handheld microphone system
Hide thumbs
Also See for ATW-251:
- Installation and operation manual (14 pages) ,
- Installation and operation manual (11 pages)
Table of Contents
Related Manuals for Audio Technica ATW-251
Summary of Contents for Audio Technica ATW-251
- Page 1 200 Series Professional VHF Wireless Systems ATW-251 UniPak ATW-251/G Guitar System ATW-251/H Headworn Microphone System ATW-251/L Lavalier Microphone System ATW-252 Handheld Microphone System Installation and Operation ™ System...
- Page 2 (/L) for particular applications. All A-T Wireless Essentials ® microphones and cables, available separately, are pre-terminated for use with any ATW-251 system. Because 200 Series packaging is designed to hold all versions of the system, some compartments in the carton are intentionally left empty.
-
Page 3: Receiver Installation
Location For best operation the receiver should be at least 3' (1 m) above the ground and at least 3' (1 m) away from a wall or metal surface to minimize reflections. Keep the receiver antennas away from noise sources such as digital equipment, motors, automobiles and neon lights, as well as away from large metal objects. -
Page 4: Transmitter Setup
UniPak ™ Transmitter Input Connection Connect an audio input device (microphone or guitar cable) to the input connector on the bottom of the transmitter. The cable connector latches automatically when inserted into the transmitter jack. To unlatch and remove the connector, simply pull up on the connector’s knurled metal collar. -
Page 5: System Operation
Adjust the output level of the receiver so the highest sound pressure level going into the microphone (or the loudest instrument playing level) causes no input overload in the mixer, and yet permits the mixer level controls to operate in their “normal” range (not set too high or too low). - Page 6 RF Interference Please note that wireless frequencies are shared with other radio services. According to Federal Communications Commission regulations, “Wireless microphone operations are unprotected from interference from other licensed operations within the band. If any interference is received by any Government or non-Government operation, the wireless microphone must cease operation...”...
-
Page 7: Specifications
Rack-mount adapter kit mounts one ATW-R250 in a single 19" rack space. ATW-RMS1 Remote mute switch designed to be installed between a wireless microphone using an HRS-type connector and its associated body-pack wireless transmitter. Includes permanently attached 22" cable and belt clip. ATW-RCS1... - Page 8 Antennas Figure A (p. 3) Receiver Controls and Functions Figure B - Front panel controls and functions Figure C - Rear panel controls and functions...
-
Page 9: Transmitter Controls And Functions
Transmitter Controls and Functions Microphone Guitar Trimmer Trimmer (MT) (GT) © © Battery-Save Switch Battery Polarity (under screwdriver clip) Diagram Figure D Figure E Battery Polarity Diagram Battery-Save Switch Figure F Gain Trimmer Screwdriver Figure G Battery Condition Indicator Power Switch... -
Page 10: Visit Our Website
One-Year Limited Warranty Audio-Technica professional wireless systems purchased in the U.S.A. are warranted for one year from date of purchase by Audio-Technica U.S., Inc. ( A. T .U.S.) to be free of defects in materials and workmanship. In event of such defect, product will be repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A.