Audio Technica ATW-701 Installation And Operation Manual
700 series professional uhf wireless systems unipak transmitter system guitar system headworn microphone system lavalier microphone system handheld dynamic microphone system
700 series professional uhf wireless systems unipak transmitter system guitar system headworn microphone system lavalier microphone system handheld dynamic microphone system (8 pages)
7000 series professional uhf wireless systems handheld condenser microphone system unipak transmitter system handheld dynamic microphone system (8 pages)
200 series professional vhf wireless systems unipak system guitar system headworn microphone system lavalier microphone system handheld microphone system (11 pages)
Page 1
700 Series Professional UHF Wireless Systems ATW-701 UniPak ™ ATW-701G Guitar System ATW-701H Headworn Microphone System ATW-701L Lavalier Microphone System ATW-702 Handheld Dynamic Microphone System Installation and Operation Transmitter System...
The circuits inside the receiver and transmitter have been precisely adjusted for optimum performance and compli- ance with federal regulations. Do not attempt to open the receiver or transmitter. To do so will void the warranty, and may cause improper operation. Notice to individuals with implanted cardiac pacemakers...
For best operation the receiver should be at least 3 ft. (1 m) above the ground and at least 3 ft. away from a wall or metal surface to minimize reflections. The transmitter should be at least 3 ft. from the receiver, as shown in Figure A. Keep...
Page 4
Two 1.5V AA alkaline batteries are recommended. UniPak™ Transmitter Battery Installation 1. Open the transmitter door by first pulling the catch down and then sliding the door upward (Fig. D). 2. Observe correct polarity as marked and carefully insert two fresh 1.5V AA alkaline batteries (Fig.
The transmitter may be either on or off when changing channels (frequencies). When changing channels with the transmitter on, the LED will turn red as the adjustment is being made; it will turn green when the channel is set.
Page 6
ATW-T701 UniPak ™ Transmitter Trim controls in the UniPak transmitter (Fig. I) will enable you to use microphones or instruments with different output levels. For MIC: Set MIC (microphone trim) control fully clockwise (maximum) and INST (instrument trim) control fully counter clockwise (low).
Each transmitter/receiver system operates on a choice of eight switch-selected frequencies. Available frequencies are shown in the chart. All frequencies may be combined for up to 8 simultaneous operating channels. OVERALL SYSTEM UHF Operating Frequency 542.125 MHz to 561.250 MHz...
Page 8
10. Turn the transmitter off when not in use. Remove the battery if the transmitter is not to be used for a period of time. Unplug the receiver from the AC outlet when the system is not in use.