Configuration Using SIMPL Windows
Using SIMPL Windows, set the display mode in slot 3 for the DM-RMC-4K-SCALER-C
Scaler. To do so, set the <Scaler_Out_Display_Mode> analog input join to the desired
value.
NOTE:
EDID
EDID (Extended Display Identification Data) configuration allows management of the EDID
that is to be sent to the upstream device connected to the DM 8G+ input of the
DM-RMC-4K-SCALER-C. By default, the EDID is set to DM default 4k 60Hz 2 ch. If a
different EDID is desired, use DMTool to configure the EDID. An overview of the steps
necessary to configure the EDID follows.
NOTE:
1. Connect to the DM-RMC-4K-SCALER-C.
2. Open the Setup window of the DM input.
3. In the EDID Configuration dialog box, configure the EDID by doing any of the
10 • DM-RMC-4K-SCALER-C/-DSP: 4K DigitalMedia 8G+ Receivers
Video Settings Dialog Box—Display Mode Configuration
For detailed information, refer to the SIMPL Windows help file.
For detailed information, refer to the Crestron Toolbox help file.
following:
•
Customize the current EDID.
•
Load an EDID template and modify it.
•
Create a new EDID file.
•
Load the existing EDID and modify it.
•
Obtain an EDID from the output and then save or customize it.
•
Apply an EDID that is saved on a computer.
Supplemental Guide – DOC. 7728A