Advertisement
P5HX-A
LBA and Large modes are new specifications which may not be fully
supported by all operating systems. An example of which is the current
version of UNIX System (R3.2.4) which is still unable to support the LBA
function. Therefore, determine the specifications of your hard disk drive
and operating system before selecting the drive's mode.
After pressing the <Enter> key on this item of the main menu, the display screen
will show the following screen.
HARD DISKS
TYPE
−
Primary Master
:
Select Primary Master
OPTIONS
SIZE
1
Note: Some OSes (like SCO-UNIX) must use "NORMAL" for installation
Figure 3 -8. IDE HDD Auto Detection Screen
Once the program detects the type of hard disk installed, it will display the relative
information such as the type, cylinders, heads, write pre-compensation, landing
zone, number of sectors per track, size and mode. A message asking you to accept
the IDE HDD detected will also be flashed on the screen.
Quitting SETUP
After making all modifications in the SETUP program, go to the option "Save &
Exit SETUP" then press the <Enter> key.
Press <Y> to confirm the changes made, and the <N> or the <ESC> keys if further
modifications are still necessary before exiting the SETUP program. Once the <Y>
key is pressed, the system will automatically exit the program and reboot.
However, if you want to cancel all changes made under the SETUP program, go to
the option "Exit Without Saving".
Press <Y> and the system will exit the SETUP program then reboot without saving
any of the changes made.
You may also use the <F10> key to save the new settings.
User's Manual 1-36
ROM PCI/ISA BIOS <<P5HX-A>>
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
SIZE
CYLS HEAD PRECOMP LANDZ SECTOR
Option (N=Skip) : N
CYLS HEAD PRECOMP LANDZ SECTOR
0
0
0
0
Esc : Skip
MODE
MODE
0
0
NORMAL
Advertisement
