Advertisement
P5HX-A
Onboard FDD Controller - Enables or Disables the FDD controller or on-board
I/O chip. The available options are:
•
Enabled (default)
Onboard Serial Port 1/2 - Sets the I/O address for serial port 1/2.
•
3F8/IRQ4 (default of Onboard serial Port 1)
•
2F8/IRQ3(default of Onboard serial Port 2)
•
3E8/IRQ4
•
Disabled
UART 2 Mode - Determines which type IR module to be used . The available
options are:
•
Standard (default)
•
HPSIR
If users set this option to
option below will not be shown on the screen.
IR Duplex Mode - Allows users to control the infrared communication duplex
mode. The available options are:
•
Half (default)
Onboard Parallel Port - Sets the I/O address for the parallel port. The available
options are:
•
378H/IRQ7 (default)
If users set this option to
option below will not be shown on the screen.
Onboard Parallel Mode - Selects the working mode of parallel port. The
available options are:
•
SPP (default)
•
EPP/SPP
1.
If users set this option to
arallel Port EPP Type" options below will not be shown on the
screen.
2.
If users set this option to
option below will not be shown on the screen.
ECP Mode Use DMA - Selects the DMA channel of ECP Mode to transfer your
data. The available options are:
•
3 (default)
Parallel Port EPP Type - Determines what version of EPP protocal to be
supported . The available options are:
•
EPP1.7 (default)
User's Manual 1-34
•
Disabled
•
2E8/IRQ3
•
ASKIR
tandard" (default), the
R Duplex Mode"
•
Full
•
Disabled
isabled", the
nboard Parallel Mode"
•
ECP/EPP
•
ECP
PP", the
CP Mode Use DMA" and
PP/SPP", the
CP Mode Use DMA"
•
1
•
EPP1.9
Advertisement
