Heat & Glo ESCAPE-30-IFT Owner's Manual page 13

3. This function lights the pilot flame ONLY to provide
enough heat in the firebox to reduce condensation in cool,
high humidity ambient conditions. To activate the Cold
Climate press and hold the Pilot button for one second and
release. The IFT-ECM will flash two green LED blinks,
beep twice and light and rectify the pilot flame when
pressed to activate. To turn off Cold Climate, press
and hold the Pilot button for one second and release.
The IFT-ECM will flash one green LED blink, beep once
and shut down the pilot flame. If remote controls are
paired with the IFT-ECM, this feature can also be
activated with the IFT-RC400 and/or IFT-RC150.
3 POSITION SWITCH
LED INDICATOR
Figure 3.6 IFT-ECM
DANGER
Risk of Explosion
DO NOT cycle the ON/OFF/REM selector
switch more than one time within a five minute
period. Gas may accumulate in firebox. Call
a qualified service technician.
Reset Switch Operation
CAUTION! Risk of burns! Appliance surfaces are hot
when operating and during cool down. Use care and
wear gloves when opening the front and accessing com-
ponents inside the appliance.
The control module (IFT-ECM) may lock out under certain
conditions. When this occurs, the appliance will not
ignite or repond to commands and is shut down. If the
IFT-ECM is in the LOCK-OUT mode, it will be necessary
to reset the control module.
The appliance has a reset switch located on the lower
right hand side of the appliance behind the decorative
barrier front. See Figure 3.7.
Heat & Glo • ESCAPE-30-IFT, ESCAPE-35-IFT Owner's Manual • 2550-981 Rev. N • 12/20
TOP VIEW
To reset the IFT-ECM Control Module:
• Be aware the appliance may be HOT, use care in
accessing the reset switch.
• Turn the appliance off at a wall switch location if so
equipped.
• Wait five minutes to allow possible accummulated gas
to clear.
• Remove decorative barrier front from appliance.
• Locate reset switch inside the appliance. See Figure
3.6. Hold reset switch down for one second and
release. A "beep" will signal module is reset.
Appliances with Wall Switch and Remote
• Turn wall switch back to "ON" position.
main menu on remote control and restart fireplace.
The fireplace will start as it would under normal
circumstances.
Appliances with Wall Switch Only:
• Turn wall switch back to "ON" position. The fireplace
will ignite as it would under normal circumstances.
Appliances with Remote Only:
• Turn fireplace back on using the main menu on the
remote control. The fireplace will ignite as it would
under normal circumstances.
• Reinstall decorative barrier front on appliance.
• If the IFT-ECM re-enters the LOCK-OUT condition
after this procedure, contact your dealer for service.
RESET SWITCH RESET SWITCH
Figure 3.7 Reset Switch Location
Appliance ON/OFF:
This appliance is supplied with a fully functional remote
control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Thermostat
• Cold Climate Feature
• Fan Speed
• Lights
Please refer to the instructions included with the remote
control for more detailed operating instructions.
Go to
13