Ryobi RBC254SBSO Operator's Manual page 38

Deutsch (Übersetzung der originalen Anleitungen)
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start. No spark.
No fuel.
Engine is flooded.
Start rope is harder to pull now
than when it was new.
Old fuel.
Engine starts but will not Engine requires approximately
ac cel er ate. three minutes to warm up.
Engine starts but will only Carburetor requires adjustment.
run at high speed at half
choke.
Engine does not reach Check lubricant fuel mixture.
full speed and emits
ex ces sive smoke.
Air filter is dirty.
Spark arrestor screen is dirty.
Engine starts, runs, and Idle speed screw on carburetor
accelerates but will not requires adjustment.
idle.
Blade continues to rotate Carburetor requires adjustment.
at idle speed.
Line will not advance. 1. Line welded to itself.
2. Not enough line on spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
English (Original instructions)
POSSIBLE CAUSE SOLUTION
The spark plug may be damaged, remove it and check for dirt and
cracks. Replace with a new spark plug.
Push primer bulb until bulb is full of fuel. If bulb does not fill, primary
fuel delivery sys tem is blocked. Con tact a servicing dealer. If prim er
bulb fills, engine may be flooded, proceed to next item.
Remove spark plug, turn unit so spark plug hole is aimed at the
ground. Rotate the choke dial to "
10 to 15 times. This will clear excess fuel from en gine. Remove
any fuel which splashed on the product. Clean and reinstall spark
plug. Clean up any spilled fuel and move at least 9m away before
restarting. Pull starter three times with choke dial at "
does not start, rotate choke dial to "
starting pro ce dure. If engine still fails to start, repeat pro ce dure with
a new spark plug.
Contact a servicing dealer.
Only use fresh fuel mixed with recommended oil. Fuel over 30 days
old may prevent the unit from starting.
Allow engine to completely warm up. If engine does not accelerate
after three minutes, contact a ser vic ing dealer.
Contact a ser vic ing dealer.
Use fresh fuel and the correct 2-stroke lubricant mix.
Clean air filter. Refer to Clean ing the Air Filter earlier in this manual.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
1. Lubricate with silicone spray.
2. Install more line. Refer to "Line Replacement" earlier in this
manual.
3. Pull lines while alternately pressing down on and releasing bump
head.
4. Remove line from spool and rewind. Refer to "Line Replacement"
earlier in this manual.
5. Advance line at full throttle.
36
" position and pull starter cord
". If en gine
" position and repeat normal