Ryobi RBC254SBSO Operator's Manual page 26

Deutsch (Übersetzung der originalen Anleitungen)
■ Always stop the engine and make sure all moving
parts have come to stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
● removing blade
● installing blade
WARNING
Never use cutting means or attachments which are not
specified by Ryobi in this manual. This includes the use of
metal multi-piece pivoting chains and flail-blades. These
items are known to break up during use and present a
high risk of serious injury to the operator or bystanders..
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or damage
to it. Any part that is damaged should be properly
repaired or replaced by an authorised service centre.
TRIMMER SAFETY WARNINGS
■ Replace string head if cracked, chipped, or damaged
in any way. Be sure the string head or blade is properly
installed and securely fastened. Failure to do so can
cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before each use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
English (Original instructions)
■ Make sure the head attachment is properly installed
■ Make sure all guards, deflectors and handles are
■ Do not modify the product in any way. This may
■ Use only the manufacturer's replacement line in the
■ Never operate unit without the cutting attachment
■ Maintain a firm grip on both handles while trimming.
BRUSHCUTTER SAFETY WARNINGS
■ In addition to the above rules, these additional
■ Use heavy-duty gloves while installing or removing
■ Do not attempt to touch or stop the blade when it is
■ A moving blade can cause severe injury. Maintain
■ Replace any blade that has been damaged. Always
■ Use only the manufacturer's replacement Tri-Arc™
■ Never cut any material over 13 mm diameter.
■ Your Brushcutter is fitted with a harness. Carefully
■ Identify the Quick Release mechanism and practice
■ Cover the blade with the blade protector before storing
24
repaired or replaced by an authorised service facility.
and securely fastened.
properly and securely attached.
increase the risk of injury to yourself or others.
cutting head. Do not use any other cutting attachment.
guard in place and in good condition.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
instructions are appropriate when using the machine
in brush cutter mode.
blades, they have sharp edges.
rotating.
proper control of the machine with both hands until the
blade has completely stopped rotating.
make sure blade is installed correctly and securely
fastened before each use.
blade. Do not use any other cutting attachment.
adjust the harness to fit comfortably and help to
support the weight of the machine at your right side.
using it before you start using the machine. Its
correct use may prevent serious injury in case of
an emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.
the unit, or during transportation. Always remove the
blade protector before using the unit. If not removed,
the blade protector could become a thrown object as