Table of Contents
Advertisement
4. Installation
Please refer to the steps below to mount the IP cameras.
EDN288MS / EDN368MS / EDN468MS:
1. Before screwing the camera to the wall/ceiling, stick the Mounting Sticker on the wall/ceiling
to mark the position for installation. Drill three screw holes on the wall/ceiling according to the
Mounting Sticker. Push the supplied 3 Screw Anchors into the holes on the wall/ceiling. Drill
another hole in the middle only if you want to run the cables through the wall/ceiling.
2. Unscrew the 3 screws using the supplied Hexagon Wrench and then remove the camera cover.
Optionally insert a micro SD/SDHC/SDXC card into the card slot.
3. Place the camera base against the anchoring surface so that the holes line up. Screw the
camera base to the ceiling/wall by using the supplied 3 Screws.
Stainless Steel 2MP/3MP/4MP Network Cameras
Drill a hole only if you want to run the
cables through the wall/ceiling.
Screw
5
SD Card Slot
Advertisement
Table of Contents
