Chassis Beam Assembly; Removing The Chassis Beam Assembly - HP x4000 Accessory Installation Manual

Installing Accessories

Chassis Beam Assembly

Chassis Beam Assembly

Before you can access many of the components inside your Workstation,
you must remove the chassis beam assembly.

Removing the Chassis Beam Assembly

To remove the chassis beam assembly:
1. Open the hard disk drive cage (see page 19).
2. Remove the screw that holds the chassis beam assembly in place.
3. Carefully rotate the chassis beam assembly off the chassis.
Figure 2-5 Chassis Beam Assembly
Step 2
22 Chapter 2
This manual downloaded from http://www.manualowl.com