Closing And Securing The Hard Disk Drive Cage - HP x4000 Accessory Installation Manual

Installing Accessories
Hard Disk Drive Cage
Figure 2-3 Hard Disk Drive Cage
Step 2

Closing and Securing the Hard Disk Drive Cage

CAUTION Clear all cables from the area where the hard disk drive cage rests on the
chassis beam assembly. If cables are in the way, you may damage them
when you move the hard disk drive cage back into the closed position.
To close and secure the hard disk drive cage:
1. Push in the clip shown in Figure 2-3 on page 20 and rotate the hard
CAUTION
2. Fasten the cage with two screws in the locations shown in Figure 2-3
20
This manual downloaded from http://www.manualowl.com
drive cage carefully into the closed position.
Do not allow the cage to drop into place. This could damage the hard
drive(s).
on page 20.
Screws for
installing a
second
hard disk
drive
Upper Bay
Lower Bay
Hard Disk
Drive Cage
Clip
Chapter 2