Figure 2-12
Removing the Graphics Card Retaining Screw
Installing a Graphics Card
To install a graphics card:
1. If you are replacing an existing card, remove the current card (see
2. Unscrew and remove the rear slot panel that corresponds AGP PRO
NOTE
Chapter 2
This manual downloaded from http://www.manualowl.com
page 32).
4X connector. The screw you removed is used to retain the graphics
card.
If you are installing a full-length graphics card, you must remove the
graphics board retaining screw near the front of the chassis as shown
in Figure 2-13.
Installing Accessories
Graphics Card
33