Installing The Chassis Beam Assembly - HP x4000 Accessory Installation Manual

Installing the Chassis Beam Assembly

To install the chassis beam assembly:
1. Hook the chassis beam assembly to the left side of the chassis and
CAUTION
2. Replace the screw that holds the chassis beam assembly in place.
Figure 2-6 MEC Retainer Clip
Retaining clip
on MEC.
Chapter 2
This manual downloaded from http://www.manualowl.com
rotate it down over the MEC and the graphics card making sure the
MEC and graphics card retainer clips are centered on the cards as
shown in Figure 2-6 and Figure 2-7.
Make sure the retaining clips slide easily over the cards, or the clips
may put undue pressure on the card connectors.
Installing Accessories
Chassis Beam Assembly
23