Xlr Outputs; Headphone Outputs; Effect Loop Send And Return; Effect Loop 1 - Art SGX-2000 User Manual

XLR OUTPUTS

The male XLR outputs are balanced outputs for use in sending your final effects
signal to a mixing board. Pin 2 is hot (+), pin 3 is negative (-), and pin 1 is
ground. The Stereo Master Output control does not effect the levels present at
this output. Use the Mains/XLR output slider on the front panel to adjust the
level at these outputs.

HEADPHONE OUTPUTS

Headphone outputs may be found on the front and rear panel. Each headphone output
is a standard 1/4" stereo jack. The Stereo Master Output control sets your final
level present at these jacks.
NOTES:
1) When a true stereo signal is applied to the inputs, the resulting output is
true stereo (dry signal only). If both outputs are used with a mono input signal,
a stereo image is produced.
2) Using one output with a mono or stereo source provides a mono signal combining
the information from both outputs.
3)The effect output is a processed combination of both the left and right input
signals.
4) When you use the Panner, make sure you are using both outputs (stereo out), if
you're using only one output you'll get NO EFFECT! This is because the two
outputs are opposite and the SGX 2000 sums the outputs, the effect signals
therefore cancel each other.
5) The headphone outputs are individually driven with their own buffer amp.

EFFECT LOOP SEND and RETURN:

EFFECT LOOP 1

Effect Loop 1 is a mono send and return located at the end of the analog section
and before the programmable seven band Equalizer. Connections are standard 1/4"
mono jacks.

EFFECT LOOP 2

Effect Loop 2 is a stereo send and return located after the Mix section.
Connections are standard 1/4" mono jacks.
NOTES:
1) When you have a device plugged into the effect loops, keep the Master Overide
switches on the front panel in. To switch the effect in and out, add the Patchbay
algorithm to the preset.
2) You may use the effect send jacks in Loop 2 as "pre-fader" outputs.
3) Use the effect send of Loop 1 as a direct out from the "preamp" section of the
SGX 2000.

MIDI OUT

The MIDI output jack is used to transmit all MIDI control information from the
SGX 2000 to whichever MIDI device is next in the chain. When using the SGX 2000
with an X-15 ULTRAFOOT, connect a MIDI cable to the 5 pin MIDI IN jack on the X-
15.

MIDI IN

This jack receives the MIDI signal containing the MIDI messages. It enables you
to "talk" to the SGX 2000 from an external source such as an X-15 ULTRAFOOT, a
4