Setting Up A Preset Sequence Including A Bypass Preset; Programming The Remote Jack For Incrementing Programs - Art SGX-2000 User Manual

in Example 3 with a footswitch. Example five shows how to program the REMOTE jack
for normal bypass operation.
EXAMPLE 3

Setting up a preset sequence including a bypass preset.

If you need to change between presets quickly without scanning or MIDI, this
procedure will be to your advantage. As in the other examples, editing the MPT is
the key. In this example we will edit the MPT to sequence through ten presets.
Ten is not the limit. You may program a sequence of 127 presets if you wish.
These presets will be in the order: 60, 151, 96, 1, 151, 35, 1, 69, 100 and 61.
Notice that we repeated some presets and included preset 100 which is set up from
the factory as a bypass preset (no effects stored in it). Remember you can assign
any preset to a MIDI number including using a preset at multiple locations. Using
an empty preset as a bypass enables you to select no effect eliminating the need
to bypass the unit from the front panel and then continuing on with an effect
preset next in the chain. NOTE: If your Mix is set for only 100% EFX, no signal
will pass through the SGX 2000.
-Make sure you are in EDIT Mode. (Press EDIT button if not)
-Press the MIDI button.
-Press the Value button, use the Encoder to change the display to:
MIDI PROG= 0
PRESET= 1_
-change between the upper and lower lines, changing the values as needed.
*MIDI program #'s will be 0 thru 9.
*follow the procedure in Example 1 if you're stuck!
EXAMPLE 4

Programming the REMOTE jack for Incrementing Programs

Program the REMOTE 1 jack on the rear panel so you may use a footswitch to
increment through a desired set of presets, operate as a normal bypass jack, or
trigger the Sampler. Remember, you may only increment up when using a footswitch
and the sequence cycles through to the beginning.
-Make sure you are in EDIT Mode. (press
-Press the UTILITY button. Change the display to read [REMOTE SWITCH 1] in the
top half and [= BYPASS ON/OFF] in the bottom half.
-Press the Value button.
-Use the ENCODER to change the number to 9.
*You have just programmed the SGX 2000 to sequence through the ten presets set in
Example 3 when using a momentary footswitch plugged into the REMOTE 1 jack.
REMOTE SWITCH 1
= INCR PROGS
NOTE: To change this to decrement presets, program the REMOTE 2 jack for
decrement following the above example.
> MIDI PROG=
>
9
0
PRESET= 60_
EDIT button if not)
49