Rotary Controls; Encoder; Drive; Second Stage Equalization - Art SGX-2000 User Manual

indicates the effect is present in the preset but has been turned "off" from an
external controller such as the X-15 ULTRAFOOT.

ROTARY CONTROLS

ENCODER

The rotary Encoder enables you to make fast and accurate changes to presets,
parameters, and values accessable in each preset or function. You will notice the
encoder will turn continuously in either direction. When adjusting values, you
may notice they sometimes "wrap" around to the beginning or end of their range.
Other times when you reach a range end you will find you must go in the opposite
direction to return to the beginning. Each click of the Encoder will change the
parameter value one step.

DRIVE

The Drive control sets the input level to the Preamp section. When the control is
set at 0, no signal is sent to the effects. Range runs from 1 to 11.

SECOND STAGE EQUALIZATION:

The Second Stage Equalizer is a five band cut and boost equalizer that allows you
to fine tune your sound from the front panel at any time without having to
program or edit a preset. Cut and boost levels are plus and minus 12 dB.

THRUST

Centered at 80Hz this controls your bottom end sound.

GROWL

At 160Hz, control the upper end of your lows and lower mids to add some depth to
the signal.

WARMTH

500Hz is the center point of this band. Use it to color and fill in the sound.

CRUNCH

The frequency center is 2.2KHz and allows you enhance the upper midrange.

EDGE

Add just what it says. The 5KHz frequency puts on (or takes away) the edge of the
sound.

TUBE DRIVE CONTOUR

Use this control to vary the harmonic balance sound of the tube. As you turn the
control from left to right the frequency goes from low to high. Accent your sound
at various frequencies to bring out the extra growl, punch, or edge to your tube
distortion sound. The most neutral setting for this control is 12:00.

LEFT/RIGHT BALANCE

The balance control pans the signal left or right to the headphone outputs and
the Line/Amp outputs. It is the last control in the signal chain.

STEREO MASTER OUTPUT

This control sets the final output level heard at the Instrument output,
Headphone outputs, and Line/Amp outputs.
7