Art SGX-2000 User Manual page 73

you want to store it elsewhere, press the Edit button and select a preset slot with the
Encoder and then press Store.
USING THE ART X-15 WITH YOUR SGX 2000 EXPRESS
RECALLING PRESETS
You can access all two hundred memory slots of the SGX 2000 Express with your X-15.
The MPT of the SGX 2000 EXPRESS may reconfigured to select the preset of your
choice to correspond with the X-15's preset number. Operate the X-15 by selecting a
"bank of ten" using the Arrow Up/Down pads, then select one of the numbered pads to
recall the preset. Press the Mode pad to enable you to turn on and off the individual
effects in the preset you've selected.
USING THE CONTROLLER PEDALS
You will notice some of the presets have MIDI controllers assigned to control an effects
parameter in the preset. Use the controller pedals on the X-15 to control the parameters. If
you set up a preset in the SGX 2000 EXPRESS, remember, you do not have to program
the X-15, all programming is done with the SGX. Refer to the main manual for
instructions to add MIDI controllers to presets.
HINTS FOR PRESETS
The first thing you should do is check out all the presets in your SGX 2000 EXPRESS.
Sure it will take time, but you really should find all the sounds we have created for you.
All presets were developed with the front panel knobs at twelve o'clock except for the
Drive and Master Output which were set at 3 o'clock. The sliders were centered. Each
preset has a Programmable Level utility built into it. Use this utility to adjust the preset's
master level to your taste. Refer to the main reference manual for hints on setting your
levels.
Organize the presets you will use in the upper memory slots starting with slot 200 and
then working down. This will help you keep them from being overwritten and in one spot
for easy reference. Access the presets you store in the upper memory slots with a preset
select pedal via the MIDI Program Table (MPT). You may assign any preset to a MIDI
Program Number. See the main reference manual for examples of editing the MIDI
Program Table.
NEW ALGORITHMS
DUAL PITCH TRANSPOSER
[DUAL PTr], [2PT]
Parameters:
:TYPE= [SMOOTH] OFF, SMOOTH, NORMAL, QUICK
:PITCH 1 = [0] (-)12 to (+)12 half steps in 1 half step increments
:FINE 2 = [0.00] (-)4.00 to (+)4.00 half steps in 0.06 (six cents) increments
7