Table of Contents
Advertisement
Bosch Rexroth AG
Mounting, demounting and electric installation
10.6 Mounting the VEP 15.6 housing devices
10.6.1 Installation notes
When mounting the embedded terminal, ensure an ergonomic operation. Ad-
●
ditionally, ensure that all moving machine components can be seen by the op-
erator at any time!
Avoid mounting locations exposed to direct sunlight, as the screen readability
●
is reduced and additional heat development can occur
When mounting the embedded terminal, ensure an easy access to the connec-
●
tor panel (top side)
Provide a minimum space of 50 mm (on all sides of the device) for sufficient
●
cooling and for cable routing
Lay all connecting cables in loops and use strain reliefs for all cables
●
Keep the maximum distance possible from interference sources
●
To maintain the degree of protection, use only cable grommets that fit to the
●
cable cross-sections for the cable bushing
Fig. 10-10: Cable bushing
Remove the cover at the rear side of the device to connect the cables. Re-
●
move the screws of the cover (see ② in
page
33) and then remove the cover
Connect all cables
●
After connecting all the cables, tighten the screws of the cover again
●
Ensure that the sealing of the cover is not damaged
●
Mount the cover correctly and fasten the screws with the correct tightening
●
torque
NOTICE
Ensure that the cover is mounted safely before switching on the device.
32/53
VEP 15.6 Multi Touch, VEP 21.6 Multi
fig. 10-11 "Position of the cover" on
Loss of degree of protection due to incorrect
opening of the housing cover.
DOK-SUPPL*-VEPXX.6MTHU-IT02-EN-P
Touch
Advertisement
Table of Contents
