Table of Contents
Advertisement
VEP 15.6 Multi Touch, VEP 21.6 Multi
Touch
NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
3.4 Explaining the signal alert symbol on the device
krax
4 Intended use
The Bosch Rexroth IndraControl VEP 15.6 and VEP 21.6 operator displays are
passive operator and visualization terminals. They form a PC-based operator ter-
minal when used with a Bosch Rexroth control cabinet PC.
NOTICE
The operator displays may only be used as intended and with the accessories,
mounting parts and other components specified in this documentation. Compo-
nents that are not expressly mentioned must neither be attached nor connected.
The same applies to cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
Typical areas of application of the operator display:
DOK-SUPPL*-VEPXX.6MTHU-IT02-EN-P
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables, lines and software and firm-
ware are used.
Bosch Rexroth AG
Intended use
5/53
Advertisement
Table of Contents
