Connecting Output Hose To The Pumps - Graco Uni-Drum Instructions Manual

Installation
Connecting Output Hose to the
Pumps
This procedure describes how to connect the fluid
output hoses to the two Pumps. It is the customer's
responsibility to have the fluid supply hose already
installed and ready for connection to the Pumps.
NOTE: For more information about the Pumps, see
Related Manuals on page 3 for the Pump instruction
manuals.
Fluid Outlet
F . 11
IG
26
There must be a minimum of 10 feet (3 m) of fluid
supply hose on the outlet to prevent damage to the
unit.
NOTE: The fluid supply hose must move freely without
kinking when the Pumps move up and down.
Check the fluid supply hose to ensure it is properly sized
and pressure-rated for this system. Use only electrically
conductive hoses. The fluid supply hose should have
spring guards on both ends. Connect the fluid supply
hose to the fluid manifold outlet.
Fluid Supply Hose
NOTICE
Fluid Manifold
TI0139
309028ZAT