Installing The Uni-Drum; Installing Drum Clamps; Installing Drum In Position Switch - Graco Uni-Drum Instructions Manual

Installing the Uni-Drum

To install the Uni-Drum, follow the procedure below.
Refer to Technical Specifications on page 94 for ram
mounting and clearance dimensions.
1. Using equipment such as a forklift or handtruck,
move the Uni-Drum into place on the floor. Remove
the shipping pallet.
2. Level the Uni-Drum, using metal shims.
3. Using the holes in the base as a guide, drill holes for
13 mm (1/2 in.) anchors.
4. Bolt the Uni-Drum to the floor using anchors that are
long enough to prevent the unit from tipping.

Installing Drum Clamps

NOTE: Drum Clamps (K) are only used with 25N914
and 25N915 Uni-Drum models. See Component
Identification on page 10.
Two Drum Clamps (K) are provided with the system to
be installed prior to system operation. The clamps hold
the drum in place while removing the Follower Plate (D).
The end user must locate and install the clamps in a
manner that will hold the drum to the frame evenly.
309028ZAT
Installing Drum In Position
Switch
NOTE: The Drum in Position Switch (L) is only used
with 25N914 and 25N915 Uni-Drum models. See
Component Identification on page 10.
A Drum In Position Switch (L) is provided with the
system to be installed prior to system operation. The
Drum in Position Switch indicates that the drum is
loaded. The end user must locate and install the switch
in a location that will indicate the drum is in position.
Connect the switch as shown below to the Pneumatic
Logic Panel (G).
Connect to
"Drum in position
signal"
F . 7: Uni-Drum Supply Switch
IG
Installation
Connect to
"Drum in position
supply port"
21