Error Code And Description; Z-Wave Command Classes - Johnson Controls KONOzw Operation Manualline

Product Model: KONOzw
If the exclusion process is not successful, then HOME screen will display ER:02 to indicate the error.
•
Press and hold the knob for over 5 seconds to return to the
exclusion.
6.3

Error code and description

Error Code
Er:00
Er:01
Er:02
Er:09
Er:0A
Er:0B
6.4

Z-Wave Command Classes

KONOzw supports the following command classes:
Association Group:
KONOzw is associated with the Zwave controller/hub in the network.
The following events will trigger a notification(report) from KONOzw to controller.
Event
Device Reset Locally
Thermostat Mode Change
Thermostat Setpoint Change
Fan Mode Change
Thermostat Operating State Change
Battery Level Change
Temperature Change
AC power connected or
disconnected
Operation Guideline
Description
System Error – Host Boot up fail
System Error – No valve (O or B) connected in Heat Pump system
Provisioning error – No network
Radio Error – No response from module
Radio Error – Poor signal (<-76dBm RSSI)
Radio Error – Network not found
Version
Group ID
Maximum Nodes
Description
Association NodeID
Report
Device Reset Locally Notification
Thermostat Mode Report
Thermostat Setpoint Report
Thermostat Fan Mode Report
Thermostat Operating State Report
Battery Report
Multilevel Sensor Report
Notification Report - Power Management
Copyright  Johnson Controls Inc 2019 All Rights Reserved
inclusion/exclusion
V2
1
5
Z-Wave Plus Lifeline
001
Page 8 of 19
menu and retry the