Advertisement
Quick Links
Parts included
• One KONOse
thermostat
®
• One Quick Start Guide
• Wall plate
• Mounting hardware
• Wire labels
Materials and tools needed
• Phillips screwdriver
• Wire stripper
• Wire cutter
• Z-Wave
Hub or Gateway to operate with KONOse
®
Installing
Risk of Electric Shock.
Disconnect all electric power sources from the old
thermostat before removing the thermostat cover.
Contact with internal components carrying hazardous
voltage can cause electric shock and may result in
severe personal injury or death.
AVERTISSEMENT
Risque de décharge électrique.
Déconnecter toutes les sources d'alimentation
électrique de l'thermostat avant de déposer le capot
de l'thermostat. Tout contact avec des composants
internes conducteurs de tensions dangereuses risque
d'entraîner une décharge électrique et de provoquer
des blessures graves, voire mortelles.
WARNING
KONOse Quick Start Guide
Risk of Electric Shock.
Disconnect the power supply before making electrical
connections. Contact with components carrying
hazardous voltage can cause electric shock and may
result in severe personal injury or death.
AVERTISSEMENT
Risque de décharge électrique.
Débrancher l'alimentation avant de réaliser tout
branchement électrique. Tout contact avec des
composants conducteurs de tensions dangereuses
risque d'entraîner une décharge électrique et de
provoquer des blessures graves, voire mortelles.
Replacing an existing thermostat
1.
Turn off the power to the heating and cooling
systems at the circuit breaker.
2.
Remove the front of your existing thermostat from
its base.
3.
Take a photo of the existing wiring for reference.
4.
Release the wires and mounting screws.
5.
Remove the base of the existing thermostat from
the wall.
Mounting your KONOse thermostat
1.
Separate the KONOse from its base.
2.
Pull the wires from the wall through the hole in the
center of the KONOse base.
3.
Use the included mounting hardware to secure the
base to the wall.
LIT-12013521
WARNING
KN-ZW-SE1-B20
2020-05-27
Advertisement
Related Manuals for Johnson Controls KONOse
Summary of Contents for Johnson Controls KONOse
- Page 1 • Phillips screwdriver • Wire stripper • Wire cutter AVERTISSEMENT • Z-Wave Hub or Gateway to operate with KONOse ® Installing Risque de décharge électrique. Débrancher l'alimentation avant de réaliser tout WARNING branchement électrique. Tout contact avec des composants conducteurs de tensions dangereuses risque d'entraîner une décharge électrique et de...
- Page 2 Connecting to a power source If the device did not add successfully, ER:02 shows on the display. Press and hold the Connect the KONOse to a C-terminal, or use the KONOse knob for more than 5 seconds to return to the with batteries.
- Page 3 Please dispose of this product in accordance with local laws and regulations in If the KONOse fails to operate within its specifications, your area. Contact your local waste disposal authorities or replace the unit. For a replacement thermostat controller, contact the nearest Johnson Controls representative.
- Page 4 © 2020 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision and are subject to change without notice. www.johnsoncontrols.com...