Data Writing - Kenwood NX-3220 K Service Manual

2.2.8.2

Data Writing

Before moving to next Zone/Channel, "Keep This Change?"
appears on the LCD, if you select "OK", the new data is written
to memory. If you select "Cancel", the new data not be written;
the new data will be erased.
• The setup items for Front panel programming mode are as
follows.
No. Setup item Display
1 RX Frequency RX Frequency Receive Frequency
2 TX Frequency TX Frequency
3 Channel Type Channel Type
4 Transmit Mode*4 Transmit Mode Analog/NXDN/DMR
5 Channel Channel Space Analog:
Spacing
• Button operation
Button\ Zone
Item Select
[ ] Decision Decision
[ ] Unused Back to the
previous item
[ ] Unused Unused
[ ] Exit panel Exit panel
program mode program mode
[] Zone change Channel
change
[] Zone change Channel
change
[] Unused Unused
[] Unused Unused
Keypad Zone number Channel
[0] ~ [9] select number select
*5
Keypad Decision Decision
[*] *5
Keypad Unused Back to the
[#] *5 previous item
Remarks
Transmit Frequency
Analog/NXDN/DMR
12.5kHz/20kHz/25kHz
Note: 20kHz is applied
for E, E2 and E3 types
only.
NXDN:
6.25kHz/12.5kHz
DMR: 12.5kHz
Channel RX
Select Frequency
Decision
Back to the
previous item
Go to the TX
Frequency
Exit panel
program mode
Fresuency up
Frequency
down
Frequency
step change
Frequency
step change
Go to the direct enter mode
Decision
Back to the
previous item
No. Setup item
6 RX Signaling
7 TX Signaling
8 RX RAN
9 TX RAN
10 Color Code
11 Slot Selection
12 Transmit Power Transmit Power Low/Medium/High
13 Channel Name
*4: In "Channel Type" display, "Transmit Mode" can be
entered only when Mixed mode is selected.
TX Channel Type
Frequency
Decision Decision
Back to the Back to the
previous item previous item
Go to the RX Unused
Frequency
Exit panel Exit panel program
program mode mode
Fresuency up Channel type
change
Frequency Channel type
down change
Frequency Unused
step change
Frequency Unused
step change
Channel number
select (1,2 or 3)
Decision Decision
Back to the Back to the
previous item previous item
Display Remarks
RX QT/DQT Receive QT/DQT
TX QT/DQT Transmit QT/DQT
RX RAN None, 1~63
TX RAN None, 1~63
Color Code 0 ~15
Slot Selection Slot 1, Slot 2
Channel Name
Transmit Mode *7 Channel
Spacing
Decision Decision
Back to the Back to the
previous previous item
item
Unused Unused
Exit panel program Exit panel
mode program mode
Transmit Mode Channel Spacing
Change Change
Transmit Mode Channel Spacing
Change Change
Unused Unused
Unused Unused
Transmit Mode Channel spacing
number select select *6
(1 or 2)
Decision Decision
Back to the Back to the
previous item previous item
(No.RA053<Rev.001>)1-11