Kenwood NX-3220 K Service Manual page 78

Item Condition
Panel tuning
mode
15. 1) Adj item:
CWID [An CWID]
Deviation Adjust:[****]
2) Adj item:
[Analog [L1]→
Narrow] [L3]→
[C2]→
[H1]→
[H3]
Adjust:[****]
PTT : ON
Press [ ]
button to store
the adjustment
value.
16. 1) Adj item:
Battery [BATT]
Warning Adjust:[****]
writing BATT terminal
voltage: 6.2V
while
transmitting.
17. [Panel test
Battery mode]
Warning 1) CH-Sig: 1-1
check BATT terminal
voltage: 6.0V
while
transmitting.
1-78 (No.RA053<Rev.001>)
Measurement
PC test mode Test-
equipment
1) Adj item: Deviation
[CWID Deviation meter
(Analog Narrow)] Oscilloscope
Deviation meter
LPF: 15kHz
HPF: OFF
2) Adj item:
[Low1]→
[Low3]→
[Center2]→
[High1]→
[High3]
Press [Transmit]
button.
Press [Apply]
button to store the
adjustment value.
1) Adj item: Power
[Battery Warning] meter
BATT terminal DVM
voltage: 6.2V
while
transmitting.
[Panel test mode]
1) Test Channel
Channel: 1
Test Signaling
Type: Analog
Signaling: 1
BATT terminal
voltage: 6.0V
while
transmitting.
Unit Terminal Unit Parts
Panel ANT Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[+], [-]
Panel ANT
BATT
terminal
Adjustment Specifications
Method
Write the value as 1.10kHz±0.10
followings. kHz
511 (Reference value)
[Panel tuning mode]
PTT: ON
Press [ ] button to
store the adjustment
value.
[PC test mode]
1) Press [Transmit]
button.
2) Press [Acquire
Monitored Value]
button.
3) Press [Apply] button
to store the
adjustment value.
Confirm that one
predetermined
numeric in the range
1 to 256 appears.
Check The
transceiver
can transmit
with causing
the LED to
blink.
/Remarks