Kenwood NX-3220 K Service Manual page 65

Antenna connector adapter
The antenna connector of this transceiver uses an SMA
terminal.
Use an antenna connector adapter [SMA(f) - BNC(f) or SMA(f)
- N(f)] for adjustment. (The adapter is not provided as an
option, so buy a commercially-available one.)
Nut wrench
In order to turn the volume nut and the channel selector nut,
use a recommendation tool.
KENWOOD part No.: W05-1123-00
Battery Jig (W05-0909-00)
Connect the power cable properly between the battery jig
installed in the transceiver and the power supply, and be sure
output voltage and the power supply polarity prior to switching
the power supply ON, otherwise over voltage and reverse
connection may damage the transceiver, or the power supply
or both.
When using the battery jig in user mode, the transceiver
assumes that a lithium-ion battery pack is attached to the
transceiver. In adjustment mode, battery type detection is not
performed.
4.15 Radio check Section
Item
Panel test mode
1. 1)CH-Sig: 1-1
Frequency PTT: ON
check
2. 1)CH-Sig: 1-1
High PTT: ON
power
check
(Battery
voltage:
2)CH-Sig: 2-1
7.5V)
PTT: ON
3)CH-Sig: 3-1
PTT: ON
Condition
PC test mode
1)Test Channel
Channel: 1
Test Signaling Type: Analog
Signaling: 1
PTT: Press [Transmit] button.
1)Test Channel
Channel: 1
Test Signaling Type: Analog
Signaling: 1
PTT: Press [Transmit] button.
2)Test Channel
Channel: 2
Test Signaling Type: Analog
Signaling: 1
PTT: Press [Transmit] button.
3)Test Channel
Channel: 3
Test Signaling Type: Analog
Signaling: 1
PTT: Press [Transmit] button.
Note:
When using the battery jig, you must measure the voltage
at the terminals of the battery jig. Otherwise, a slight
voltage drop may occur within the power cable, between
the power supply and the battery jig, especially while the
transceiver transmits.
Schematic diagram
S
–
+
Measurement
Test- Unit Terminal Unit Parts
equipment
f. counter Panel ANT
Power meter Panel ANT
Ammeter
+ Terminal (Red)
– Terminal (Black)
–Terminal
(Black)
Power Power
cable
supply
+
+Terminal
(Red)
Adjustment Specifications
/Remarks
Method
Check an ±0.5ppm
internal ±77.5Hz@
temperature 155.1MHz
of radio from
20°C to
33°C.
Check 4.0~6.0W
2.0A or less
(No.RA053<Rev.001>)1-65