Programming; Overview; Port Assignments By Ni Model; Master Send_Commands - AMX NI-2000 Programming Manual

Programming

Overview

This section describes the Send_Commands, Send_Strings, and Channel commands you can use to
program the Integrated Controller. The examples in this section require a declaration in the
DEFINE_DEVICE section of your program to work correctly. Refer to the NetLinx Programming
Language instruction manual for specifics about declarations and DEFINE_DEVICE information.

Port Assignments By NI Model

Port Assignments By NI Model
NI Model
NI-700
NI-900
NI-2000
NI-3000
NI-4000
NI-2100
NI-3100
NI-4100
NI-3101-SIG

Master Send_Commands

These commands are specific to the Master and not the Controller. These commands are sent to the DPS
0:1:0 (the Master you are connected to).
A device (<DEV>) must first be defined in the NetLinx programming language with values for the
Device: Port: System (<D:P:S>).
Master Send_Commands
Command
CLOCK
Set the date and time on the
Master.
NI Series WebConsole & Programming Guide
RS-232/422/485 IR/Serial
Ports 1 - 2 Port 3
Port 1 Ports 2-4
Ports 1 - 3 Ports 5-8
Ports 1 - 7 Ports 9-16
Ports 1 - 7 Ports 9-16
Ports 1 - 3 Ports 5-8
Ports 1 - 7 Ports 9-16
Ports 1 - 7 Ports 9-16
Ports 1 - 6 Ports 9-16
Description
The date and time settings are propagated over the local bus.
Syntax:
SEND_COMMAND <DEV>,"'CLOCK <mm-dd-yyyy> <hh:mm:ss>'"
Variables:
mm-dd-yyyy = Month, day, and year. Month and day have 2 significant digits.
Year has 4 significant digits.
hh-mm-ss = Hour, minute, and seconds. Each using only 2 significant digits.
Example:
SEND_COMMAND 0,"'CLOCK 04-12-2005 09:45:31'"
Sets the Master's date to April 12, 2005 with a time of 9:45 am.
Programming
IR/RX Relays
Port 5 Port 4
Port 6 Port 5
Port 4 Port 9
Port 8 Port 17
Port 8 Port 17
Port 4 Port 9
Port 8 Port 17
Port 8 Port 17
Port 8 Port 17
I/O
81