AMX NI-2000 Programming Manual page 58

WebConsole - System Options
This opens the Edit Options window (FIG. 34), where you can select which Diagnostics messages
to enable or disable for this device.
FIG. 34 Edit Options window
Once you have selected the diagnostics messages to enable, click Update to apply your changes,
close the Edit Options window, and return to the Diagnostics page.
Refer to the Diagnostics Options Definitions section on page 52 for definitions of each Diagnostic
option.
3. The device that you just enabled diagnostics for appears in the Diagnostics Options page (identified
by its Number, Device and Port assignments at the top of the Diagnostics Option list), with the
currently enabled diagnostics indicated with a green checkmark (FIG. 35).
50
Click to delete this device from the Diagnostics page
(disables all diagnostics on this device)
Click to apply changes
Click to close the Edit Options window
(without disabling diagnostics)
Click to select from Presets
(saved sets of enabled Diagnostic messages)
Click to Store and Recall Presets
To set Diagnostic Options for a different System
Device, enter the device's System, Device and Port
information in these fields (and press Update to
add the specified device/diagnostics options
to the Diagnostics page).
Click the checkboxes to enable/disable
specific diagnostic messages
Scroll down to see the entire list.
(All Notifications enables all messages)
NI Series WebConsole & Programming Guide