LG LS-B0760CM/B0760HM Service Manual page 35

3. Attach the Grille onto the cabinet.
• Grasp lower the left and right side of the Grille
and engage two tabs on the top in side edge of
the grille with two slots on the cabinet's top front
edge.
• Press the grille toward the cabinet until it will be
back into place.
• Secure the grille to the cabinet with two screws.
2) Form the pipings
1. Wrap the connecting portion of indoor unit with
the Insulation material and secure it with two
Plastic Bands.(for the right pipings)
• If you want to connect an additional drain hose,
the end of the drain-outlet should be off the
ground.(Do not dip it into water, and fix it on the
wall to avoid swinging in the wind.)
In case of the Outdoor unit to be installed
below the position of the Indoor unit.
2. Tape the Pipings, drain hose and Connecting
Cable from down to up.
3. Form the pipings gathered by taping along the
exterior wall and fix it onto the wall by saddle
or equivalent.
In case of the Outdoor unit being installed
upper position of the Indoor unit.
2. Tape the Pipings and Connecting cable from
down to up.
3. Form the pipings gathered by taping along the
exterior wall, make the Trap to be required to
prevent the room from entering the water.
4. Fix the pipings onto the wall by saddle or
equivalent.
Seal a small opening
around the pipings with
gum type sealer.
•
Trap is required to prevent the electrical
parts from entering the water.
- 35 -
Taping
Drain hose
Pipings
Connecting
Plastic band
cable
Seal a small opening
around the pipings
with gum type sealer.
Trap