LG LS-B0760CM/B0760HM Service Manual page 22

2) Indoor Unit Installation
The mounting wall should be strong and solid enough
to prevent it from the vibration.
1. Mount the installation plate on the wall with
four Type "A" screws.
• Always mount the Installation plate horizontally by
aligning the marking-off line with using the thread
and a level.
2. Drill the piping hole with 70mm dia. holecore
drill.
• Drill the piping hole at either the right or the left and
the hole should be slightly slant to the outdoor side.
Type "A" screw
The lower left and right side of Installation
Plate
Left rear piping
80mm
ø70mm
Left rear piping
Center
ø70mm
Indoor
- 22 -
Installation Plate
marking-off line
Thread
Weight
<7K, 9K BTU>
Right rear piping
50mm
<11K, 12K, 14K BTU>
Right rear piping
A A
Center
A
A
ø70mm
WALL
Outdoor
ø70mm