Bowflex Treadmill 22 Service Manual page 62

17. After noting how the Zip-Tie secures the Speed Sensor Cable to the
Frame, cut the Zip-Tie that secures the Speed Sensor Cable.
18. Attach the new Speed Sensor to the Frame, but do not fully tighten
the hardware.
19. Secure the new Speed Sensor Cable to the Frame just as the old
Cable was secured. If the Cable is not secured in the same manner, there
is the potential to damage the Cable during re-assembly.
20. Rotate the Drive Pulley until the Speed Sensor Magnet is beside the
Speed Sensor. With the Speed Sensor Magnet centered on the Speed
Sensor, fully tighten the hardware that attaches the Speed Sensor. Be
sure that the Magnet is centered after tightening.
21. Cut the remaining Zip-Ties that secure the Speed Sensor Cable (3
shown here).
22. Remove the Speed Sensor Con-
nector from the Motor Control Board.
23. Route the new Speed Sensor
Cable along the Frame.
24. Attach the new Speed Sensor Con-
nector to the Motor Control Board.
25. Using replacement Zip-Ties, secure
the Speed Sensor Cable to the Frame
and trim the excess from the Zip-Ties.
Be sure not to cut the Speed Sensor
Cable.
Zip-Tie
Speed Sensor
Cable
Zip-Ties
Speed Sensor Cable
Speed Sensor Connector
62