Bowflex Treadmill 22 Service Manual page 39

10. Installation of the Incline Motor Assembly is the reverse procedure.
Note: Be sure to attach the cables to the proper locations on the Motor Control Board. Do not crimp any cables.
11. Make sure there is sufficient space to tilt the machine back upright and that the area is clear. Tilt the machine upright being sure not to grasp the
Console or Walking Belt.
This step requires two people. Be sure there is adequate clearance for the machine. Some components of the equipment can be
heavy or awkward. Enlist the service of a second person when you do maintenance steps involving these components. Do not try
to do heavy or awkward steps on your own.
Do not grasp the Console or the Walking Belt to tilt the machine onto the side. The Console could be damaged, and the Walking
Belt could abruptly move.
12. Re-install all remaining parts that were removed in reverse order.
13. Attach the power cord and turn on the Treadmill by flipping the power switch to ON.
14. From the Power Up screen, tap on the upper-right corner of the Console Display 10 times. The Console will display the "Advanced User Actions "
menu.
15. From the "Advanced User Actions " menu, tap CALIBRATE in the upper right corner of the Console Display. The Console will shift to Calibrate
mode.
16. From the "Calibrate" menu, tap CALIBRATE_MCB.
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing on or under the Walking
Belt, or near the Treadmill.
17. The Console will display "CALIBRATE_MCB-USER CONFIRM". Tap it, and the calibration procedure starts.
Note: The calibration procedure will begin by automatically moving the Walking Belt and adjusting the incline of the Walking Deck.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
18. When calibration is complete, the Console will display "CALIBRATE MCB - PASS".
19. Tap EXIT in the upper-right corner of the Display to exit the Calibrate Mode.
20. Flip the power switch to OFF. Calibration is now complete for the machine.
21. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
39