Editing An Existing Macro Within The Project - AMX AXT-CA10 Instruction Manual

Using the DXP-PRO Wizard
FIG. 21 Navigation and Routing Macros dialog

Editing an existing Macro within the Project

1. Select a macro from the Macros table.
2. To edit these newly added Macros, either double-click on the macro entry (from the Macros
table) or select the entry and press the Edit button. These actions both open the Macro Steps
for...dialog wherein you can edit the various properties of the selected macro.
62
Each navigation and routing macro may contain up to 50 steps, the following sections
outlines more specific information on using macros.
These Macros would have been previously created within the Device Configuration -
Device Data tab by selecting the Use Macro for Menu Navigation and Device Routing
radio button (for a selected Source Type (if available)).
To modify the macro steps, click the Edit button at the bottom of this dialog. These
macros can be edited within the Macros Steps for... dialog but cannot be added unless
you return to the Device Configuration page for a selected product and choose the "Use
Macro for Menu Navigation and Device Routing" check box.
By previously selecting the Use Macro for Navigation and Device Routing radio box
(for a particular device from within the Device Configuration - Device Data tab), a
macro entry (for the selected device) is made into the Navigation and Routing Macros
dialog (FIG. 22). This entry can now be modified if necessary, but no new macros can be
added to the Navigation and Routing Macros dialog without first returning to the Device
Data tab and selecting the radio box.
DXP-PRO v1.1 - Programmer's Guide