Note For Radia Lighting Systems; Touch Panel Interfaces Dialog - AMX AXT-CA10 Instruction Manual

Using the DXP-PRO Wizard

Note for Radia Lighting Systems

On Radia lighting systems, channels 1-128 represent Radia lighting presets 1-128. If a channel is
on, then the corresponding preset is on. However, on startup NetLinx resets all channels to 0 (OFF).
Radia does not report the status of its channels when the Master comes up, and consequently the
software believes the state of all of the presets is OFF. Therefore, until a preset changes in the
system, the channel states are not reported.
It is important to have the Lighting Preset information prior to finishing the project.

Touch Panel Interfaces Dialog

Design XPress - Professional (DXP-PRO) requires that at least one touch panel is defined within
the system (FIG. 11). You can define up to 8 touch panels in the system.
FIG. 11 Touch Panel Interfaces dialog
46
Enter a new Preset Name, Address and Button Number, and click the Add button to add a
new preset to the bottom of the list.
Select a Preset in the list and click the Delete button to delete that preset from the list.
The Insert button inserts a new preset at the order number of the currently selected
preset.
Click the Apply button after editing a preset to apply the changes.
The Clear button clears the Preset Name, Address and Button Number information for a
selected preset.
The default
panel Device
ID is 10501.
Each
consecutive
panel that is
added to the
project
increments
this value by
a value of 1.
Determines
the menu
bar on the
panel
Excludes
these menu
items from
being
displayed
on the panel
DXP-PRO v1.1 - Programmer's Guide