Step 7 Connect Cables
When connecting chassis connectors to the motherboard, make sure to connect the correct connector end. Most connector wires are color-
coded. Match the color of the wires leaving the switch or LED to the same pin on the connector end. There may be more than one
connector with the same color-coded wires. If so, follow the wire to the switch or LED. Pin 1 of all connectors is indicated on the
motherboard by a pointed box around the connector. Pin 1 is always at the pointed end of the box, as shown below:
Connect the following cables to the following jumpers on the motherboard:
• Reset switch cable to J46,
• Speaker cable to J40,
• external battery connector to J18,
• Keyboard lock cable to J41,
• Turbo LED cable to J54, and
• IDE Activity Indicator LED cable to J47.
J46 Reset Switch Connector
J46 is a two-pin single-inline berg that is attached via a cable to an externally-mounted reset switch. When the reset switch is pressed, the
system performs a hard reset. Pin 1 is ground and Pin 2 is Hard Reset.
Chapter 3 AMIBIOS and WINBIOS
32
Cont'd